METBD 410

Reverse Engineering Project

Documentation of Final Surface Geometry

Create a word document showing the shaded views of the car as shown above.

Create B size drawing as shown below. This is really the same drawing as used for documenting the digitized data, but now showing the final datum curves used as well as reference dimensions for overall size. The orthographic views are full size.

Detail of note in lower left corner of drawing (needed for printing):

Attach a page answering the following questions:

Surface Creation Assessment

What discoveries did you make about the surface creation process during the execution of this assignment?

If you had an opportunity to start over again, what would you do different?

Do you feel you were adequately prepared to tackle this project based on prior lab experiences?

If not, what suggestions do you have to enable others to be more prepared?

Were the instructions for this assignment clear, and if they weren’t what suggestions do you have on making them clearer?

Any other Comments: