METBD 410

Reverse Engineering Project

Documentation of Digitized Data

Create a B size drawing shown the front, top and right side views of the data you collected using the MicroScribe Digitizer. Include an isometric in the right corner.

The three principle views should be full size, the isometric at some scale.

Place a note in the lower left corner as follows:

RAW DIGITIZED DATA

NAME OF VEHICLE

Print on A size paper.

Answer the following questions (separate sheet using a word processor).

Digitizing Assessment:

What did you learn from digitizing you vehicle?

How long did the setup take (decision on what data to collect, taping operation etc.)

How long did it actually take to collect the data?

Were the instructions on setting up and using the digitizer clear?

If not, what suggestions do you have on making them easier to understand.

Any other Comments: